Forum

Pages: [1]   Go Down
  Print  
Author Topic: tolerances  (Read 948 times)
mike211
Newbie
*
Offline Offline

Posts: 4


« on: September 19, 2012, 06:21:25 PM »

This a comment for this page on the website
So how often did you have to repeat the measurements to get that nice and plausible ranking of D800E, then D800, then D600? I would say, all those results are within measurement tolerances, so it could as well have been the other way round.
Logged
Pages: [1]   Go Up
  Print  
 
Jump to:  


Powered by SMF 1.1.19 | SMF © 2013, Simple Machines